Applying Vinyl Siding Starter Strip

The bottom of the starter strip the part the bottom panel hooks on to should be at least.

Applying vinyl siding starter strip.

This is where the new siding will begin. From that point measure up 1 4 6 4mm less than the width of the starter strip and partially drive a nail at one corner. Find the lowest corner of the old siding or sheathing on the house. Cap the corner posts.

Snap a level chalk line for the first starter strip at the base of the wall no less than 8 inches above ground level after determining the lowest corner of the house. Determine the lowest point of the wall that will be sided. Measure a spot that is 1 1 2 inches above the bottom edge of the sheathing at this lowest point using a tape. Partly drive a nail 11 2 in.

Installing inside corner. Insulation for vinyl siding 1. Nail the starter strip to the siding aligning the top of the strip with the chalk line. Insert the flat hooked end of the zip tool under the lip on the bottom most edge of the vinyl siding panel that rests on top of the starter strip.

Staret strip secures the first course of siding to the home. Pull up as. Nail vertical vinyl corners to the corners of the house making sure they are plumb. Attach j channel trim strips around windows and doors and along the eaves.

13 simple vinyl siding installation tips use the wider starter strip. Position starter strip with the top edge of chalk line and allow room for corner posts. Pull the zip tool down while simultaneously. Slide it into the corner and nail it every 16 in.

Snap each length of siding in place so that its bottom lip hooks under the starter strip. This video shows how to install a starter strip for vinyl and polymer siding installation. This chalk line should be level and a consistent distance from the eaves or the top and bottom of the windows. How to install a vinyl siding starter strip step 1.

Vinyl siding starter strips. Mice bees and all sorts of other critters love making their home inside vinyl corner posts. Be sure to center the nails in their slots to. Locate the lowest possible corner that has sheathing.